12/17/2023 0 Comments Hanging folder drawer rails![]() ![]() ![]() It saves you money and you get to charge for a custom product. It slides great consistently and there’s no hardware to fall apart, give, or bend under weight. If you are using hardwood you can also just cut a rabbet on the outside of the box leaving a built-in file hanger. All of this hardware is very inexpensive, so my suggestion would be to get samples and see which system works best for you. There is a cross member that snaps onto the side rails in a pre-located position (there are two of them) so it can accept letter and/or legal files running side-to-side. I had to order two separate items - the clips and aluminum rail material and in my opinion it doesn't look as good.Īlso, the CompX system which comes in two sizes (letter and legal front-to-back), works with both letter and legal files. I needed a special shop made jig to speed up installation and even then it was fairly slow. I used to use Contributor D's hardware and was happy with it for years, but switched to the CompX because the price was similar. Uses no tools and snaps together in less than one minute. You just need a pendaflex folder to set the width, either legal or letter. Sturdy frame is designed to hold file folders in conventional file cabinets. I get it from Hafele for less than $10.00 and it installs in less than ten minutes with tin snips and a drill. ![]() You can use it for any size drawer, standard or lateral files. The last few I've done I used a metal hanger clip from Hardware Resources that the bar stock fits into. I know what you mean about them getting out of the shop prior to slotting for the hang bar. With the plastic rails that fit on the side do you have the ability to adjust the width of the drawer? Or are you stuck with the one size due to the width of the file? Our typical drawer body is a 3/4" product. I have used these plastic extrusions in the past for file drawers.Ĭlick here for higher quality, full size image Sometimes we use Pendaflex hanging file brackets that the bar fits into, but those are very pricey. If it doesn't get done in the shop before the cabinets go out it is a pain to do that in the field. They fit any length drawer because the rails are scored. How do you guys handle hardware for file drawers that file from front to back? Do you use hangers, route a slot for the bar to fit into, or something else? We have been cutting slots in the drawers on a table saw and that is time consuming. Adapt older file cabinets to accept hanging folders with these inexpensive and easily assembled frames. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |